Audi 80/90/Coupe
+ 1.2. Identification of the car
+ 2. Engines, carburetors
3. Lubrication system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Exhaust system
+ 7. System of ignition
+ 8. Transmission
- 9. Suspension brackets, wheels
9.1.1. Elimination of resonance / vibration of a cross-piece (4-cylinder models)
9.1.2. Change of a design of a forward suspension bracket
9.1.3. Half shaft
9.1.4. Suspension bracket rack
9.1.5. CV JOINTS
9.1.6. Suspension bracket rack (all-wheel drive models)
9.1.7. CV JOINTS (all-wheel drive models)
+ 9.2. Back suspension bracket
+ 9.3. Wheels and tires
+ 10. Brake system
+ 11. Steering
+ 12. Body, salon
+ 13. Air conditioning system
+ 14. Electric equipment
|
Forward suspension bracket – drafts and half shafts
1. Rubber plug
is established only on models with 4-cylinder engines
2. Stabilizer of cross stability
3. Plug of the stabilizer of cross stability
4. 35 N. of m.
5. Arm
6. Clip
it is necessary to install the plug of the stabilizer of cross stability correctly
7. 40 N. of m.
8. 40 N. of m.
after twisting till the required moment of an inhaling turn in addition on a quarter of a turn (90 °)
9. Bolt and washer
always replace
10. Plug of the lever of a forward suspension bracket
11. Rubber plug of the stabilizer of cross stability
12. 65 N. of m.
13. Spherical hinge
note the provision of installation at removal from a rack of the wheel bearing
adjust disorder of forward wheels after installation
14. Lever of a forward suspension bracket
differ on a design on the left and right side
15. Plug
insert into the rubber plug
|
16. Connecting draft
establish so that sides were at right angle to the direction of the movement of the car
17. 35. N of m.
turn in addition on a quarter of a turn
always replace
18. Washer
always replace
19. Plug of the stabilizer of cross stability
20. Bolt
the head has to look forward
21. 65 N. of m.
22. Plug
23. 20 N. of m.
24. Back plug of a cross-piece of a forward suspension bracket
25. Cross-piece of a forward suspension bracket
various modifications for models with 4-and 5-cylinder engines
delay fastenings in the following order:
1. Back left
2. Back right
3. Forward left
4. Forward right
26. Forward plug of a cross-piece of a predny suspension bracket |
Prevention
Do not try to carry out welding works or to level elements of a forward suspension bracket which are responsible for fastening and installation of wheels. At repair always replace always replace all bolts, washers and самоконтрящиеся nuts, the fixing suspension bracket elements, such as a cross-piece of a forward suspension bracket, suspension bracket levers, the stabilizer of cross stability, spherical hinges etc.
|
|